Adhesive Contents

A Single-component, Solvent-based Adhesive  

Where to use?

It is used for bonding polythene and rubber isolation, acoustic isolation to pipe and air duct installations.  It is produced as an alternative to rubber-based and similar products. After the application, the surfaces should be bonded quickly.  Maximum adhesive strength is obtained for durability, if application is made within the appropriate drying time. Since the drying time of adhesive and reaction will change due to the weather change on the construction site, this product is recommended when fast drying is required in the application conditions.

Caution! During temperature decreases or excessive temperature rises, pay too much attention to drying time.

How to use?

Before the application, remove any oil, dirt and dust on the surface to be applied.  Apply adhesive content to cover the entire surface.

After the applied surface remained open for the waiting period, the bonding process is realized by placing the isolation on the surface. The waiting period may vary depending on the amount of adhesive and ambient temperature.

Properties:

•    Appearance: Honey-colored liquid
•    Chemical composition: Synthetic rubber, resin and solvents.
•    Viscosity:  400 + 100 cps
•    Dry substance content:  40%+ 1
•    Specific gravity: Approx. 1.2 gr/cm³
•    Boiling point: 40° – 70°C
•    Volatility weight %: Approx. 60%
•    Flash point: It does not flash
•    Drying point: 5 – 10 min. (depending on the ambient temperature)

Storage Conditions:

Store at temperatures lower than 25°C. Shelf life is 1 year from the production date.

Caution:

AS IT IS A SOLVENT-BASED PRODUCT, IT SHOULD BE USED IN A CONTINUOUSLY AND EFFECTIVELY VENTILATED ENVIRONMENT IN TERMS OF OCCUPATIONAL SAFETY AND HEALTH.